Oops. Just discovered this group.  I was wondering what happened with 
that idea!

I put a lot of time from this round's entry on trying to push through a 
workflow which would involve modelling a figure in Wings, importing into 
P4 using Phibuilder, then posing the figure in P4 and exporting either 
to Wings for fine tailoring or to Poseray for conversion to POV.  I had 
some success with this but there are still major obstacles to it being a 
useful workflow.  In the end I found I could pose my figure more 
effectively in Wings itself.  But I learned a lot about Poser, .phi and 
.cr files so far.

Post a reply to this message